Cross Technologies 2015-26 Bedienerhandbuch PDF herunterladen (Seite 7)

C) Commands Table 1.2 lists the commands for the 2015-26 and briefly describes them. After a command is

sent the 2015-26 sends a return “>” indicating the command has been received and executed.

General Command Format - The general command format is {aaCND...}, where:

{ = start byte

aa = address (RS-485 only - option Q)

C = 1 character, either C (command) or S (status)

N = 1-digit command or status number, 1 through 9

D = 1 character or more of data (depends on command)

} = stop byte

* PLEASE NOTE: The two character {aa}(00-31) prefix, in the table below,

should be used ONLY when RS-4

85, (OPTION-Q), is selected.

Table 1.2 2015-26 Commannds

Commands

Command Syntax* Description

Set Transmitter Frequency {aaC1xxxx} where:

• xxxx = 4 characters standard (7 characters -Option-X)

• Range: 2000 to 2500 MHz

Set Input Level {aaCIxx} where:

• xx = 2 characters

• Range: 10 to 40 (-10 to -40 dBm, in 1 dB steps)

Set Transmit Gain {aaC3xxxx} where:

• Standard 1 dB step format:

- xxx = 2 char (0 to 30dB), or 3 char (-10 to -01dB) if neg.

- Range: -100 to 300 (-10.0 dB to +30.0 dB, in 0.1 dB steps)

• Z OPTION (0.1 dB steps):

- xxxx = 3 char (0 to 300dB), or 4 char (-100 to -001dB) if neg.

- Range: -100 to 300 (-10.0 dB to +30.0 dB, in 0.1 dB steps)

Enable Tx {aaCAx} where x =:

• 0 to disable Tx signal

• 1 to enable Tx signal

Enable External 10MHz {aaCEx} where x =:

• 0 to disable External 10MHz ref signal

• 1 to enable External 10MHz ref signal

Enable Remote # Just # sign

Disable Remote {aaCR0} {CR and zero}

2015-26 Manual, Rev. 0 Page 7 12/09/10

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Keine Kommentare

Cross Technologies 2015-26 Bedienerhandbuch Seite 7