Cross Technologies 2015-58T Bedienerhandbuch

Instruction Manual Model 2015-58 UpconverterJune 2014, Rev. FMENUEXECUTEMODEL 2015CROSS TECHNOLOGIES INC.F = 5950.000

2.4 Installation / Operation2.4.1 Installing and Operating the 2015-58 Upconverter1. Connect a -35 dBm to -10 dBm, 70 MHz signal to IF IN, J4 (Figu

2.5 Menu Settings2.5.1 Functions - This section describes operation of the front panel controls. There are three operator switches, the LCD display

2.5.2. Power On SettingsNOTE: The last status of a unit is retained even when power is removed. When power is restored, the unit will return to it&

2.5.4 Frequency ChangesAt any time during the modification process, if you have made a mistake and do not wish to save the changes you have made, d

2.5.5 Gain ChangesWhen you get to this menu note that the gain changes will be made as you make them but if you do not wish to save the changes you h

2.5.5 Alarm IndicationsAn alarm condition for will occur if the local oscillator phase lock loop (PLL) comes out of lock. The Mute LED will light if

CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB www.crosstechnologies.com E

INSTRUCTION MANUALMODEL 2015-58 Upconverter TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Description 31.2 Technical Characteristics 4

MODEL 2015-58 Upconverter1.0 General1.1 Equipment DescriptionThe 2015-58 Upconverter converts 70 ± 18 MHz to 5.85 to 6.425 GHz in 125 kHz steps with

1.2 Technical CharacteristicsTABLE 1.1 2015-58 Upconverter Specifications*Input Characteristics (IF)Impedance 75ΩReturn Loss 18 dBFrequency 70 ±

1.3 Monitor and Control InterfaceA) Remote Serial InterfaceProtocol - RS-485, RS-422 or RS-232C (selectable), 9600 baud rate, no parity, 8 data bits,

B) Commands - Table 1.2 lists the commands for the 2015-58 and briefly describes them. After a command is sent the 2015-58 sends a return “>” indi

1.4 Use InformationA. Elevated operating ambient temperature - if installed in a closed or multi-unit rack assembly, the operating ambient temperatur

2.0 Installation2.1 MechanicalThe 2015-58 consists of one RF/Controller PCB which is housed in a 1 RU (1 3/4 inch high) by 16 inch deep chassis. A

2.2 Rear Panel Input / Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.ACGNDJ1810 MHZ REFOUTPUTJ10ANDMONITORCONTR