Instruction Manual Model 1582-650 RF Switch January 2011 Rev C STATUSALARMHISTORYHISTORYRESETALARMSWITCHMANUALSELECTCH1AUTOCH
3.0 Environmental Use InformationA. Rack-Mounting - To mount this equipment in a rack, please refer to the installation instructions located in the u
CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB: www.crosstechnologies.com
INSTRUCTION MANUALMODEL 1582-650 RF Switch TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Description 31.2 Technical Characteristics 42.
MODEL 1582-650 RF Switch1.0 General1.1 Equipment DescriptionThe 1582-650 RF Switch provides Auto, Manual or Remote relay switching between CH1 and C
1.2 Technical CharacteristicsTABLE 1.1 1582-650 RF Switch Specifications*Switch Characteristics Impedance 50 Return Loss > 18 dB, DC to 4 G
2.0 Installation2.1 MechanicalThe 1582-650 consists of one RF/Controller PCB housed in a 1 RU (1 3/4 inch high) by 12 inch deep chassis. Redundant
2.2 Input and Output Signals - Figure 2.2 shows the input and output connectors on the rear panel. AC1GNDJ2 - RF OUTPUT A (COMMON)SWITCH COMMON RF
FIGURE 2.3 1582-650 Front Panel Controls and Indicators2.3.1 PC Board Settings NOTE: Dot position means jumper goes from pins 1-2; non-dot means jum
2.4 Operation1. Set the on board controls as desired (Tables 2.2, 2.3, Figure 2.3).2. Install the 1582-650 in the equipment rack.3. Connect RF to the
2.5 Switch Mode SetupThe following gives the switch mode settings of the on board controls that can be changed in the field with JP1, JP2, JP3, JP4;
Kommentare zu diesen Handbüchern