Instruction Manual Model 1582-71/72 RF Switch June 2011 Rev. C MODEL 1582 SWITCH CROSS TECHNOLOGIES, INC.POWER 1 2 AUT
remotely if both channel alarms are clear or both channels are in alarm. The initial channel can also be selected if both channel alarms are clear or
2.5 Switch Mode SetupThe following gives the switch mode settings of the on board controls that can be changed in the field with JP1, JP2, JP3, JP4;
3.0 Environmental Use InformationA. Rack-Mounting - To mount this equipment in a rack, please refer to the installation instructions located in the u
CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB www.crosstechnologies.com E
INSTRUCTION MANUALMODEL 1582-71/72 RF Switch TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Description 31.2 Technical Characteristi
MODEL 1582-71/72 RF Switch1.0 General1.1 Equipment DescriptionThe 1582-71 provides Auto, Manual or Remote relay switching between CH1 and CH2 RF sig
MODEL 1582 SWITCHPOWER 1 2 AUTO ON-LINEMANUAL SELECTREMON-LINEALM CH 1 CH 2ALMMAN RESET SWITCH CROSS TECHNOLOGIES, INC.1582-71 FRONT
1.2 Technical CharacteristicsTABLE 1.1 1582-71/72 RF Switch Specifications*Switch Characteristics Impedance 75 , 50 optionalType RelayIsolati
2.0 Installation2.1 MechanicalThe 1582-71/72 consists of one RF/Controller PCB and one smaller PCB containing the RF inputs and outputs. It is hous
2.2 Input and Output Signals - Figure 2.2 shows the input and output connectors on the rear panel. AC1GNDJ7AC2J4A1J5AJ6A2114J1B1J2BJ3B2A, B - RF &
2.3 Controls and Indicators - The following are the front panel controls and indicators. POWER1 2SWITCH AUTO ON-LINEMANUALSELECTREMON-LINEALM
2.3.1 PC Board Settings NOTE: Dot position means jumper goes from pins 1-2; non-dot means jumper goes from pins 2-3JP1 - 3-pin jumper - 3-pin jumper
Kommentare zu diesen Handbüchern