Cross Technologies 2416-x02 Bedienerhandbuch PDF herunterladen (Seite 9)

Table 1.2 lists the commands for the 2415-x02 and briefly describes them. After a command is sent the

2415-x02 sends a return “>” indicating the command has been received and executed.

General Command Format - The general command format is {aaCND...}, where:

{ = start byte

aa = address (RS-485 only)

C = 1 character, either C (command) or S (status)

N = 1 character command or status request

D = 1 character or more of data (depends on command)

} = stop byte

* PLEASE NOTE:

Commands specific to a channel must be preceded

by *i where i is the channel number.

* PLEASE NOTE:

The two character {aa}(00-31) prefix, in the table below,

should be used ONLY when RS-485 is selected.

Table 1.2 2415-x02 Commandds

Commands

Table 1.2 2415-x02 Commands

Command Syntax* Description

Set Channel Frequency

{aa*iCFxxxxxxx}

where i = :

• 1, 2, 3 or 4 designating the channel number

• xxxxxxx = frequency in KHz

Set Channel Gain {aa*iCGxx} where i = :

• 1, 2, 3 or 4 designating the channel number

• xx = gain to nearest 1.0 dB (e.g., {1CG15} sets channel 1 gain to 15 dB.)

Set Channel Mute {aa*iCMx} where i = :

• 1, 2, 3 or 4 designating the channel number

• x = 1 for Mute ON (carrier OFF)

• x = 0 for Mute OFF (carrier ON)

10 MHz reference mode {aaCEx} where x = :

• 0 for internal 10 MHz; 1 for external 10 MHz; 2 for auto detect

Reference insertion on output {aa*iCLx} where :

• i = 1, 2, 3 or 4 designating the channel number

• x = 0 for non-insertion; 1 for insertion

Reference offset/adjust {aaCOxxxxx} where x = :

(Option O) • xxxxx = an offset amount between -2000 & +2000

IF Output Frequency {aa*iCYx} where i = :

(Option W160/70) • 1, 2, 3 or 4 designating the channel number

• x = 0 for 70 MHz IF, 1 for 160 MHz IF

2415-x02 Manual, Rev. A Page 9 02/25/15

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Cross Technologies 2416-x02 Bedienerhandbuch Seite 9